一开始抓release版的iscsitarget-0.4.15.tar.gz
不过编不起来
后来改抓svn版本
$ svn co svn://svn.berlios.de/iscsitarget/trunk
make;make install编译安装都正常
编辑设定档:
$ vi /etc/ietd.conf
Target iqn.2007-09.candyz:storage.test
Lun 0 Path=/dev/sdb4
Alias iSCSI
$ vi /etc/initiators.allow
iqn.2007-09.candyz:storage.test 192.168.1.0/24
$ vi /etc/initiators.deny
ALL ALL
$ /etc/init.d/iscsi-target start
iscsi initiator
$ yum install iscsi-initiator-utils
$ iscsiadm -m discovery -t sendtargets -p 192.168.1.23:3260
$ /etc/init.d/iscsi start
同时跑iscsi-target跟iscsi的机器，iscsi-target要在iscsi之前先跑
$ dmesg
Loading iSCSI transport class v2.0-724.
iscsi: registered transport (tcp)
iscsi: registered transport (iser)
scsi4 : iSCSI Initiator over TCP/IP
scsi 4:0:0:0: Direct-Access IET VIRTUAL-DISK 0 PQ: 0 ANSI: 4
sd 4:0:0:0: [sdc] 32515560 512-byte hardware sectors (16648 MB)
sd 4:0:0:0: [sdc] Write Protect is off
sd 4:0:0:0: [sdc] Mode Sense: 77 00 00 08
sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled, doesn’t support DPO or FUA
接下来就可以fdisk mkfs mount umount等来使用了。
