parting-line

parting-line什么意思,parting-line翻译

基本解释

n.: 分型线
网络: 分模线；分膜线；相关词条

英汉解释

• 分型线

例句

• If the parting line cannot be on a single plane, then it is good practice to use symmetry of the design to minimize the side thrust forces.

  如果分模面不能在单一平面，利用设计的对称性来减小侧向推力不失为一种好方法。

• Coining is usually done on surfaces parallel to the parting line, and little metal flow is involved in the operation.

  铸币通常是做表面平行的线，与小金属流动是参与行动的。

• The gate location, ejector pin location and parting line (especially cosmetic surface) must be approved by US before tooling .

  入水、顶针位置以及分型线（特别是外表面）等在加工前必须得到美国确认。

• The seam between them is the parting line.

  两部分之间的接合处是分界线。

• The drag is first filled partially with sand, and the core print, the cores, and the gating system are placed near the parting line.

  先将下型箱装上部分型砂，安放好型芯座、型芯，浇通系统应放置在分型线附近。

• The methods of parting direction determination, parting line and parting surface generation were presented and analyzed.

  对脱模方向的自动确定、分型线和分型面的自动生成方法进行了介绍和分析；

• since the draft angle was changed, we need to lower the parting line for the mold.

  由于角度改变，模具分型处要降面。

• 2 gate, vents parting line, and ejector pin locations must be approved by XXX prior to die construction.

  浇注前，浇道、排气道以及起模杆的铺设位置必须经过XXX的批准。

• In this paper, a new approach to automatically searching the parting line in injection mold design is introduced.

  提出了一种自动搜索模具分型线的方法。

• ALL UNSPECIFIED EXTERIOR (NON-APPEARANCE SURFACE) EDGES TO BE 0. 13 MAXIMUM RADIUS, EXCEPT AT PARTING LINE.

  所有未指明的外型（非外表面）边缘最大半径为0.13，分型线处除外。